cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
RemiB
Engaged Sweeper II

Hello Lanseeper Community, i have issue with scanning my Cisco Switch.

- in my IP range the (no ssh) box not checked.

-In my switch config SSH is enable and i create an acount with full acces(15) 

-After that i made a ssh credential on lansweeper with the right user name and password and i put the credential on my ip range .

What im doing wrong?

1 REPLY 1
mwrobo09
Champion Sweeper

RemiB,

Did you map the credential to the IP of that device, or to the scanning range under Scanning Credentials and then down below in the Credential Mapping section?

New to Lansweeper?

Try Lansweeper For Free

Experience Lansweeper with your own data.
Sign up now for a 14-day free trial.

Try Now