cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Esben_D
Lansweeper Employee
Lansweeper Employee

Hey everyone,

Below you can find a custom OID file for import into Lansweeper to monitor some vital information on your Palo Alto firewalls.

To get started simply do the following:

Verify that your Lansweeper is on version 7.1 or higher. If needed you can update here.

  • Download the OID file below.
  • Import the OID file.
  • Make sure to verify the target is correct, I created a new dynamic group with all Palo Alto devices.
  • Rescan your Palo Alto devices.
6 REPLIES 6
Esben_D
Lansweeper Employee
Lansweeper Employee
Awesome, thanks for sharing guys!
studerje
Engaged Sweeper II
Very helpful.
on ours, i also added
System Uptime OID 1.3.6.1.2.1.25.1.1.0
GlobalProtect client package version: 1.3.6.1.4.1.25461.2.1.2.1.15.0
HA State: 1.3.6.1.4.1.25461.2.1.2.1.11.0
HA Peer State: 1.3.6.1.4.1.25461.2.1.2.1.12.0
System Software Version: 1.3.6.1.4.1.25461.2.1.2.1.1.0

If I did it correctly, I've added my exported oid file.
Dov
Engaged Sweeper III
Ever since custom OID scanning became available I've been trying to have Lansweeper pull the PANOS version from the firewalls, with no luck, Lansweeper shows 'No data found'.
The OID is 1.3.6.1.4.1.25461.2.1.2.1.1, doing a MIB walk confirms it.
Has anyone else tried the same OID with better results?
Cheers,
Dov

JTempleton
Engaged Sweeper III
Dov wrote:
Ever since custom OID scanning became available I've been trying to have Lansweeper pull the PANOS version from the firewalls, with no luck, Lansweeper shows 'No data found'.
The OID is 1.3.6.1.4.1.25461.2.1.2.1.1, doing a MIB walk confirms it.
Has anyone else tried the same OID with better results?
Cheers,
Dov



Good day!

Change the OID to: 1.3.6.1.4.1.25461.2.1.2.1.1.0
JTempleton
Engaged Sweeper III
Here is another OID you can use for the Palo Alto:

GlobalProtect gateway active tunnels: 1.3.6.1.4.1.25461.2.1.2.5.1.3.0
JacobH
Champion Sweeper III
Thank you for this!