cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
ke-burgmann
Engaged Sweeper
Hello,

I'm new here, but I got some problems about scanning every computer in the company. We got around 120 computers that there have been scanned, and 66 who does'nt got scanned. The setup is the same on every computer.

This is the error we keep getting on those 66 computers:
The RPC server is unavailable 0x800706BA (DKVLAP019.KEB.Local, DKVLAP019, 10.47.20.47)

Anyone in here who knows what that could be ?

Thank you.
5 REPLIES 5
Hemoco
Lansweeper Alumni
Remote admin mode should be set to "enabled" as seen in http://www.lansweeper.com/kb/firewall.aspx
ke-burgmann
Engaged Sweeper
Hello again Lansweeper,

I have tryed this command "netsh firewall show state" on a computer that works with the scan from lansweeper and one who doesnt work.

And both saying the same thing I just uploaded a picture how the config is:

http://img718.imageshack.us/img718/4547/firewall.jpg

We are both running Windows 7 Ultimate, hope you have an idea how to fix this problem 🙂



Thanks for you time so far 🙂
Hemoco
Lansweeper Alumni
Please check the following link: http://www.lansweeper.com/kb/notfound.aspx
You can check the firewall state on these computers by using "netsh firewall show state"
ke-burgmann
Engaged Sweeper
Hello,

If its a firewall problem, how can it be that the most of the scans going through? They all got the same setup.
Hemoco
Lansweeper Alumni
if 10.47.20.47 is the correct IP address of the computer it's most likely a firewall problem.