→ Upcoming Keynote Event - Introducing Lansweeper's 2023 Spring Release: 'Duvel' - Learn More

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Susan_A
Lansweeper Employee
Lansweeper Employee

When you link your local Lansweeper installation with Cloud, a number of prerequisite checks are performed to ensure your installation is ready to link. Normally, after the prerequisite checks are successful, the initial push of your Lansweeper installation to Cloud will succeed. However, sync errors can still occur under certain conditions. For instance, if your Lansweeper server loses internet access after the completion of the prerequisite checks and the submission of your Cloud details, your initial push will fail. This article explains some steps you can take to resolve an initial push failure.

1. Make sure your installation is up to date

To ensure full compatibility with Cloud, make sure your Lansweeper installation is up to date. Update instructions can be found in the knowledge base.

2. Use retry button if available

If your initial push failed for a reason that could be resolved with a retry, the Lansweeper web console may offer you the Retry initial push now button. If available, this button is displayed in the Troubleshooting column of the Configuration > Link With Cloud Site menu. If your internet connection was lost after submitting your Cloud link settings for instance, use the button to retry the sync. Of course, a retry in the previous situation will only succeed if your internet access is restored in the meantime and if you meet the other Cloud requirements.

cloud-initial-push-retry.png

3. Unlink and relink

In some situations, the retry button may not be offered because the initial push failed in a way that cannot be resolved with a manual retry. If no retry button is offered in the Cloud menu or if the sync still fails after a retry, you can try removing the link to Cloud and adding it again. Select Unlink from Cloud site and wait for the unlink to complete. Afterward, you can select Link with Cloud site to try the link again.

unlink-from-cloud-site.png

4. Check prerequisites

Pay close attention to any potential failures in the Cloud prerequisite checks. Review the details of the failure and resolve it by following the instructions in the prerequisite check tooltip.

5. Check log files

If the initial push to Cloud continues to fail and the cause is unclear, the log files below may contain additional info on the failure. They can be found on your Lansweeper server. Note that sync_errorlog.txt and web_errorlog.txt will only exist if errors actually occurred in your Cloud sync or web console, respectively. Program Files (x86)\Lansweeper\Service\errorlog.txt Program Files (x86)\Lansweeper\Service\sync_errorlog.txt Program Files (x86)\Lansweeper\Website\App_Data\web_errorlog.txt

6. Check your proxy settings

Syncing with Cloud requires an almost constant data stream between your on-prem sync server and Cloud. To limit bottlenecks and ensure future readiness, Lansweeper chooses only to allow syncing to Cloud using HTTP2-enabled proxies. If your Lansweeper installation uses a proxy connection for outbound traffic, make sure HTTP2 is enabled or create an exception rule to bypass the proxy for the endpoint edge.lansweeper.com.

Was this article helpful? Yes No
No ratings

New to Lansweeper?

Try Lansweeper For Free

Test Drive Lansweeper Yourself. Explore our interactive Demo or sign up for free 14-day trial.

Try Now
Knowledge Base Dashboard
Article Dashboard
Version history
Last update:
‎04-12-2023 04:16 PM
Updated by: