I'm not sure if this is working as intended, but all of my reports (both the ones created by myself and the ones that are built in Lansweeper) show as 0 until they are opened at which point they populate with the correct # for further viewing.
Please contact support@lansweeper.com and provide us with screenshots of: - The behavior you're describing. - Configuration/Scanning Setup/Your License. - Configuration/Website Management/Website Access.
Lansweeper wrote: Please contact support@lansweeper.com and provide us with screenshots of: - The behavior you're describing. - Configuration/Scanning Setup/Your License. - Configuration/Website Management/Website Access.
Okay, information has been sent.
Archive
This board contains archived posts from the retired Lansweeper Forum and Insiders Community.
