We’re currently experiencing a high volume of support requests, which may result in longer response times — thank you for your patience and understanding.
I'm not sure if this is working as intended, but all of my reports (both the ones created by myself and the ones that are built in Lansweeper) show as 0 until they are opened at which point they populate with the correct # for further viewing.
Please contact support@lansweeper.com and provide us with screenshots of: - The behavior you're describing. - Configuration/Scanning Setup/Your License. - Configuration/Website Management/Website Access.
Lansweeper wrote: Please contact support@lansweeper.com and provide us with screenshots of: - The behavior you're describing. - Configuration/Scanning Setup/Your License. - Configuration/Website Management/Website Access.
Okay, information has been sent.
Archive
This board contains archived posts from the retired Lansweeper Forum and Insiders Community.
