
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎05-02-2016 11:40 AM
Hi,
I am using the UltraVNC Viewer 1.1.9.6 and would like to use it from LANSweeper. I put the vncviewer.exe at the action path of lansweeper$. I add action command line as follows:
C:\Program Files\UltraVNC\vncviewer.exe" "{ipaddress}:10203" . When I try to use the VNC action on asset The vncviewer is execute but the ipaddress is not recognize .
Thanks,
Eyal.
I am using the UltraVNC Viewer 1.1.9.6 and would like to use it from LANSweeper. I put the vncviewer.exe at the action path of lansweeper$. I add action command line as follows:
C:\Program Files\UltraVNC\vncviewer.exe" "{ipaddress}:10203" . When I try to use the VNC action on asset The vncviewer is execute but the ipaddress is not recognize .
Thanks,
Eyal.
Labels:
- Labels:
-
Custom Actions
1 REPLY 1

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-19-2016 03:12 PM
My action entry look like this
The vncviewer.exe is located at
{actionpath}vncviewer.exe {ipaddress}
The vncviewer.exe is located at
C:\Program Files (x86)\Lansweeper\Actions, so you don't need the full path.
