
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-08-2016 09:48 AM
Hi,
we have the following problem.
while deploying software we got an error that Deployment paused for 5 min, we are already deploying on this asset.
But there is no deployment actually.
Is it possible, to kill the deployment for this workstation?
Restarting the lansweeper service does not resolve the problem.
lansweeper version is 6.0.0.17.
we have the following problem.
while deploying software we got an error that Deployment paused for 5 min, we are already deploying on this asset.
But there is no deployment actually.
Is it possible, to kill the deployment for this workstation?
Restarting the lansweeper service does not resolve the problem.
lansweeper version is 6.0.0.17.
Solved! Go to Solution.
Labels:
- Labels:
-
General Discussion
1 ACCEPTED SOLUTION

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-11-2016 07:44 PM
I recently ran into this with a poorly written program and installing using the command line interface. Look for the processes associated with global username you are deploying with, and kill them. Even when you have the deployment set to timeout after 5 minutes it may not stop. It's the way the program installs that could be the problem.
1 REPLY 1

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-11-2016 07:44 PM
I recently ran into this with a poorly written program and installing using the command line interface. Look for the processes associated with global username you are deploying with, and kill them. Even when you have the deployment set to timeout after 5 minutes it may not stop. It's the way the program installs that could be the problem.
