Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎06-30-2015 03:05 PM
Hy all,
In configuring methode>Ip range> the section SCHEDULE if RECURRING EVERY (1 minutes) will this activate a scan every one minute, even if this is RANGE is not ENABLE?
Thank you
Dan
In configuring methode>Ip range> the section SCHEDULE if RECURRING EVERY (1 minutes) will this activate a scan every one minute, even if this is RANGE is not ENABLE?
Thank you
Dan
Solved! Go to Solution.
Labels:
- Labels:
-
General Discussion
1 ACCEPTED SOLUTION
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎06-30-2015 04:01 PM
1 minute is the shortest interval which is possible. Enabling a scanning interval of only 1 minute should not be done except you are scanning only a very small IP range of selected assets and have a reason for this short scanning interval. You can increase the number of minutes or change "minutes" to "hours". And no, if the IP range is not enabled, Lansweeper won't perform scans.
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎06-30-2015 04:01 PM
1 minute is the shortest interval which is possible. Enabling a scanning interval of only 1 minute should not be done except you are scanning only a very small IP range of selected assets and have a reason for this short scanning interval. You can increase the number of minutes or change "minutes" to "hours". And no, if the IP range is not enabled, Lansweeper won't perform scans.
