
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-04-2014 03:52 AM
Hello,
I noticed the quicksearch doesn’t pick up the system’s name if I put in the full FQDN (pc.domain.org).
It works if I only put in the systems name or it’s IP address. Not sure if this is intentional?
PS. Great software BTW!
I noticed the quicksearch doesn’t pick up the system’s name if I put in the full FQDN (pc.domain.org).
It works if I only put in the systems name or it’s IP address. Not sure if this is intentional?
PS. Great software BTW!
Labels:
- Labels:
-
Archive
1 REPLY 1

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-06-2014 10:23 PM
This is expected behavior. For performance reasons, the search bar only supports a limited number of fields, which are listed on page 85 of our online documentation: http://www.lansweeper.com/documentation.pdf
Note that you can create a custom report that lists the FQDN and filter the report within the report results to perform a "search". To create a basic report, open the report builder under Reports/Create New Report, tick the FQDN field in the tblAssets table, submit a report title and hit the Save & Run button.
Note that you can create a custom report that lists the FQDN and filter the report within the report results to perform a "search". To create a basic report, open the report builder under Reports/Create New Report, tick the FQDN field in the tblAssets table, submit a report title and hit the Save & Run button.
