Multiple domain scanning

[asa]

Hello,

I have a couple of questions for the new 3.5 version multiple domain scanning :

1. When trying to add credentials for the new domain it returns error that cannot veryfy it. I'm sure I have correct username/passwrod for this domain. How computer with Lansweeper actually can find other domains? They are located on different subnets and NETBIOS broadcast obviously does not work. Any extra configuration is needed? There is no trust bettwen domains and they are in the different forests.
2. I've addet credential for the domain which has a trust with domain of Lansweeper so it can verify credentials in this case but nothing happened i.e computers from the new domain are not scanned and domain does not appear on the console. Active scanning is enabled. What else has to be done?

Thanks
Andrei

[Hemoco]

Confirmed as a problem, will be fixed in 3.5.1

[asa]

Unfortunately as I mentioned the domains are absolutely independent and no trust possible between them.

[asa]

Yes.
Also I've read a parallel discussion and I can mention we do not have any single account which can read all domain controllers as domains are absolutely independent and do not have any common thin in between. IT it a requirement it basically kills possibility to use Lansweeper for multiple domains.

[Hemoco]

asa wrote:
Yes.
Also I've read a parallel discussion and I can mention we do not have any single account which can read all domain controllers as domains are absolutely independent and do not have any common thin in between. IT it a requirement it basically kills possibility to use Lansweeper for multiple domains.

Do the domains have trusts?

[Hemoco]

Maybe a stupid question but did you entered the license key.

[asa]

Yes the new domain has been added to the list of domain for active scanning

[Hemoco]

1. When trying to add credentials for the new domain it returns error that cannot veryfy it. I'm sure I have correct username/passwrod for this domain. How computer with Lansweeper actually can find other domains? They are located on different subnets and NETBIOS broadcast obviously does not work. Any extra configuration is needed? There is no trust bettwen domains and they are in the different forests.

Just for this there is a checkbox just below the password : "Don't try to authenticate"

2. I've addet credential for the domain which has a trust with domain of Lansweeper so it can verify credentials in this case but nothing happened i.e computers from the new domain are not scanned and domain does not appear on the console. Active scanning is enabled. What else has to be done?

Did you add the domain you want scanned to the list of domains for active scanning?