cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
X9017
Engaged Sweeper

I would like to scan just one computer.  here's my scenario:  the computer was already initially scanned.  In those results we discovered that windows was not up-to-date.  so we updated it.  rather than re-scanning the entire network. I just want to rescan that one computer.  What is the best way to do this?  I looked under Asset-> Computer Name, but i cant see where to do this?

Alternatively I can setup a single scanning target and change that IP address. but that is a lot longer to setup.

How can I scan the single computer that is already listed?  thanks.

1 ACCEPTED SOLUTION
KevinA-REJIS
Champion Sweeper II

You should be able to go to the Asset's webpage, and Rescan asset link is in the top left. 

View solution in original post

2 REPLIES 2
X9017
Engaged Sweeper

Oh thank you!  I'm not sure why I didn't see that.  I don't think it is placed in the right spot.  but it is there. thanks!

KevinA-REJIS
Champion Sweeper II

You should be able to go to the Asset's webpage, and Rescan asset link is in the top left.