One-button-option to manually start the scanning of one IP range

[MartinG]

I know about the work-around to deselect the active option of all IP ranges and only leave the one enabled that you want to scan. But that is a very tiresome and ineffective way of doing it, because you normally will have to reverse the ticking exercise immediately afterwards.

I like to have the ability to scan a defined IP range with a button or link from within the respective row.

[MartinG]

Thanks again :-)!

[Susan_A · Accepted solution]

Such an option already exists in the Lansweeper 6.0 beta. In the beta, each scan target (e.g. IP range) under Scanning\Scanning Targets has its own Scan Now button. If you haven't already, contact support@lansweeper.com and include "beta" in the title of your message to be added to our list of beta testers.