→ 🚀What's New? Explore Lansweeper's Fall 2024 Updates! Fall Launch Blog !

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
steffen
Engaged Sweeper II

We have installed new access points in the network and configured them accordingly for SNMP.
The problem:
There is only a single entry for an access point, and when a new scan of the network is performed, you can see how the AssetID is overwritten from device 1 to device 10 by continuously refreshing the page. At the end of the scan, a single entry with device 10 is displayed in the list.
It can be observed that IP and MAC, etc., are correctly shown for the respective device at that moment during the scan.
What could be causing this?

1 ACCEPTED SOLUTION
steffen
Engaged Sweeper II

We solved the problem. It was a pseudo Mac-address that was identical across the access points.
We had to blacklist the mac and now ist scans the assets correctly.

Solved: Merging of assets - Lansweeper Community - 48608

View solution in original post

1 REPLY 1
steffen
Engaged Sweeper II

We solved the problem. It was a pseudo Mac-address that was identical across the access points.
We had to blacklist the mac and now ist scans the assets correctly.

Solved: Merging of assets - Lansweeper Community - 48608

New to Lansweeper?

Try Lansweeper For Free

Experience Lansweeper with your own data.
Sign up now for a 14-day free trial.

Try Now