OT Supported Protocols

[sophie]

This page provides information on the supported protocols for Lansweeper OT and instructions on adding custom protocol configurations.

---

Lansweeper OT allows you to scan various vendors' devices with supported protocols. 

Various protocols are supported by default, but you can also add protocol configurations as necessary. 

For an overview of Lansweeper OT, see Lansweeper for OT Asset Management.

Supported protocols

The table below shows a list of supported protocols, as well as associated vendors and their devices.

Some vendors may be supported that are not listed, so long as they use a supported protocol.

You can also view a list of supported protocols in the Hub > Protocols.

OPC UA is supported by multiple vendors.

Vendor	Devices	Protocols
ABB		EtherNet/IP IEC-61850
Beckhoff		TwinCAT ADS
GE		IEC-61850
Itron		IEC-61850
Lantronix	xPico Series​ xPort Series​ xPress Series​ UDS200​ UDS1100​ UDDS2100​	Lantronix
Mitsubishi	Melsec iQ-R Series​ Melsec L Series​ Melsec Q Series​	IEC-61850 Melsec
Moxa	ioLogik E1200 Series (EtherNet/IP)​ NPort 5100 Series​ NPort 6100 Series​ NPort 6200 Series​	EtherNet/IP Moxa
Omron	CJ1G Series CJ1M Series CJ2H Series CJ2M Series CP1H Series CP1L Series CP2E Series CS1H Series NJ Series NSJ Series	EtherNet/IP Fins
Phoenix Contact	AXC Series ILC Series	EtherNet/IP PCWorx
Rockwell	Armorblock CompactLogix ControlLogix FlexLogix Kinetix MicroLogix PanelView PLC-5 Powerflex SLC 500 Smartguard	EtherNet/IP
Schneider Electric	HMIG Series (Modbus) Magelis XBTGT Modicon M221 Modicon M258 Modicon M262 Modicon M340 Modicon M580 Modicon Quantum	BACnet EtherNet/IP IEC-61850 Modbus
SEL		EtherNet/IP IEC-61850
Siemens	ET200 ET200S IM361 S7-1200 Series S7-1500 Series S7-300 Series S7-400 Series Simatic PLCs Sinumerik	BACnet EtherNet/IP IEC-61850 Siemens S7-300/400​ Siemens S7-1200/1500
Vipa	300 series	Siemens S7-300/400​ Siemens S7-1200/1500

Add protocol configurations

You can create a custom protocol configuration to scan your OT devices, if necessary. 

To add a protocol configuration:

1. In the Hub, go to Protocols.
2. Select Add new.
3. Enter a name and protocol.
4. Enter the advanced configuration details.
5. Select Save.

Don't see the protocol you need? Please complete this request form and we'll contact you!

---

Was this post helpful? Select Yes or No below!
Did you have a similar issue and a different solution? Or did you not find the information you needed? Create a post in our Community Forum for your fellow IT Heroes!
More questions? Browse our Quick Tech Solutions.

---