Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎05-31-2016 09:36 AM
Is there a way to see which scanning rule has added an asset to the database? That would be very helpful to fine-tune the scanning rules to avoid unwanted assets in the db.
Solved! Go to Solution.
Labels:
- Labels:
-
Report Center
1 ACCEPTED SOLUTION
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎06-07-2016 08:30 PM
You can check the Scan Time tab of a Windows computer's Lansweeper webpage to see which scanning method or scanning target type scanned the machine and when. This information is also stored in the tblAssets database table, i.e. in the fields LastActiveScan, LastIPScan... This won't tell you the exact scanning target responsible for adding the asset, but it will at least tell you which scanning target type is responsible. In Lansweeper 6.0, scanning targets can be adjusted in the Scanning\Scanning Targets section of the web console.
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎06-07-2016 08:30 PM
You can check the Scan Time tab of a Windows computer's Lansweeper webpage to see which scanning method or scanning target type scanned the machine and when. This information is also stored in the tblAssets database table, i.e. in the fields LastActiveScan, LastIPScan... This won't tell you the exact scanning target responsible for adding the asset, but it will at least tell you which scanning target type is responsible. In Lansweeper 6.0, scanning targets can be adjusted in the Scanning\Scanning Targets section of the web console.
