
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎12-05-2009 04:26 AM
Hi,
I built a clean system and turn off the firewall (for now until I figure out what needs to be open on firewall) to get the LanSweeper to get the info from the client. However, I notice in Lansweeper it only shows the MAC address of the wired adapter in my ThinkPad T60 client which has both wired and wireless adapters built-in. Wireless is turned off but I thought MAC address should be stored some where in the registry or system config so LanSweeper should be able to get it.
Can someone tell me this is expected behavior? I need to collect the MAC addresses for all the mobile clients even if they are connected to network via wired connections.
Thank you!
I built a clean system and turn off the firewall (for now until I figure out what needs to be open on firewall) to get the LanSweeper to get the info from the client. However, I notice in Lansweeper it only shows the MAC address of the wired adapter in my ThinkPad T60 client which has both wired and wireless adapters built-in. Wireless is turned off but I thought MAC address should be stored some where in the registry or system config so LanSweeper should be able to get it.
Can someone tell me this is expected behavior? I need to collect the MAC addresses for all the mobile clients even if they are connected to network via wired connections.
Thank you!
Labels:
- Labels:
-
Archive
1 REPLY 1

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎12-05-2009 07:34 PM
The mac adresses are stored in the database (you can create a custom report to show them)
The website only shows the adapters with ipenabled=true
The website only shows the adapters with ipenabled=true
