Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎01-14-2016 11:17 PM
What considerations are there if I DST-NATed a port to my LANSweeper server so that LSPush works on laptops that are rarely home?
Solved! Go to Solution.
Labels:
- Labels:
-
General Discussion
1 ACCEPTED SOLUTION
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎01-19-2016 10:25 AM
We can't really provide instructions or support for setting something like this up, but the default port used by LsPush is 9524. LsPush will only work with direct server connection if inbound traffic over this port is allowed on your Lansweeper server. You can configure your own, custom LsPush port as well, in the Service Options section of Configuration\Server Options. If you do, don't forget that a restart of the Lansweeper Server service is required for this change to take effect.
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎01-20-2016 10:35 PM
An alternative to this is posted here
http://www.lansweeper.com/Forum/yaf_postst5771_lspush-smtp-direct-send.aspx#post25521
basically have lspush run locally and email the file to you. then deal with the file and drop it into the IMPORT folder of lansweeper.
you could most likely automate this a bit.
http://www.lansweeper.com/Forum/yaf_postst5771_lspush-smtp-direct-send.aspx#post25521
basically have lspush run locally and email the file to you. then deal with the file and drop it into the IMPORT folder of lansweeper.
you could most likely automate this a bit.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎01-19-2016 10:25 AM
We can't really provide instructions or support for setting something like this up, but the default port used by LsPush is 9524. LsPush will only work with direct server connection if inbound traffic over this port is allowed on your Lansweeper server. You can configure your own, custom LsPush port as well, in the Service Options section of Configuration\Server Options. If you do, don't forget that a restart of the Lansweeper Server service is required for this change to take effect.
