
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎06-24-2013 03:52 AM
Is it possible to tell LANsweeper to scan a particular IP address if it doesnt already have an asset page, that doesnt involve scanning entire ranges?
Labels:
- Labels:
-
Archive
1 REPLY 1

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎06-24-2013 07:18 PM
- Create an IP range that only includes the required IP in the IP Address Range Scanning section of Configuration/Scanning Setup/Scanning Methods.
- Hit the Disable All IP Ranges button.
- Re-enable only the required range.
- Hit the Scan All Enabled IP Ranges Now button.
- When scanning has completed, hit the Enable All IP Ranges button.
- Hit the Disable All IP Ranges button.
- Re-enable only the required range.
- Hit the Scan All Enabled IP Ranges Now button.
- When scanning has completed, hit the Enable All IP Ranges button.
