Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-21-2010 12:51 PM
Hi, I have my own tables in Lansweeper database. Is this a problem for upgrade.
Labels:
- Labels:
-
Archive
7 REPLIES 7
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-22-2010 10:43 AM
It is all right. The problem was when the upgrade process seemed to be stopped.
Thanks.
Thanks.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-21-2010 05:02 PM
The upgrade script might run several hours depending on the size of the database.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-21-2010 04:43 PM
I left running the update again. After it were, seemingly, stopped during several hours, begins to run again but very slowly. It is running since 11:40.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-21-2010 01:28 PM
I have tried to update serveral times. The installation hangs updating the database. The last attemp raise an access violation. Here is the screen:
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-21-2010 12:58 PM
Yes, i've the "Adm_" prefix.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-21-2010 01:01 PM
cheche wrote:
Yes, i've the "Adm_" prefix.
Should be no problem.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-21-2010 12:57 PM
Do you have any specific prefix in front of the tables?
Normally no tables are deleted but I recommend a full backup before upgrading.
Normally no tables are deleted but I recommend a full backup before upgrading.
