
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎11-23-2015 08:49 PM
Hello!
Actually I can deploy to my domain computers, now I need to do a package for a specific workgroup computers but, I can't even ping their netbios names from my Lansweeper server, only using their IP address.
I'm wondering if anybody has done this before? Any ideas?
Thanks
Actually I can deploy to my domain computers, now I need to do a package for a specific workgroup computers but, I can't even ping their netbios names from my Lansweeper server, only using their IP address.
I'm wondering if anybody has done this before? Any ideas?
Thanks
Solved! Go to Solution.
Labels:
- Labels:
-
General Discussion
1 ACCEPTED SOLUTION
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎11-23-2015 11:46 PM
setup local account on the workgroup pc with local admin rights.. make sure all the needed ports are enabled (run the lansweeper.vbs ) script to enable needed stuff. enter the scanning credentials for that specific workgroup inside lansweeper and deploy package after scanning that PC using the IP SCAN function
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎11-23-2015 11:46 PM
setup local account on the workgroup pc with local admin rights.. make sure all the needed ports are enabled (run the lansweeper.vbs ) script to enable needed stuff. enter the scanning credentials for that specific workgroup inside lansweeper and deploy package after scanning that PC using the IP SCAN function
