cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Azkor
Engaged Sweeper II
Is there a variable in the reporting system that I can set to exempt subnets from the report? For example I have 2 subnets dedicated to non persistent VM's and I dont need to report against them.
1 ACCEPTED SOLUTION
Bruce_B
Lansweeper Alumni
You could set those assets to any asset state other than "Active" as most built-in reports will exclude these. When you create a new custom report this filter is also automatically incorporated (Where tblAssetCustom.State = 1).

It is possible to exclude subnets from reports but you'd have to add filters based on IP address to each individual report.

View solution in original post

1 REPLY 1
Bruce_B
Lansweeper Alumni
You could set those assets to any asset state other than "Active" as most built-in reports will exclude these. When you create a new custom report this filter is also automatically incorporated (Where tblAssetCustom.State = 1).

It is possible to exclude subnets from reports but you'd have to add filters based on IP address to each individual report.