
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎01-13-2014 09:19 AM
Hi!
Where can I see all S.M.A.R.T data for a computers harddrive(s)?
I would like to make a report that make an "alert" if any bad sectors are detected. My experience of the S.M.A.R.T system is that it allow too many errors before it change from status "OK" to "bad".
Where can I see all S.M.A.R.T data for a computers harddrive(s)?
I would like to make a report that make an "alert" if any bad sectors are detected. My experience of the S.M.A.R.T system is that it allow too many errors before it change from status "OK" to "bad".
Solved! Go to Solution.
Labels:
- Labels:
-
General Discussion
1 ACCEPTED SOLUTION

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎01-20-2014 02:13 PM
Instructions on how to set up event log alerts can be found on pages 70 and 148 of our online documentation: http://www.lansweeper.com/documentation.pdf
Note that an email will be sent each time the specified event occurs.
1 REPLY 1

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎01-20-2014 02:13 PM
Instructions on how to set up event log alerts can be found on pages 70 and 148 of our online documentation: http://www.lansweeper.com/documentation.pdf
Note that an email will be sent each time the specified event occurs.
