
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
a month ago
Hi Community ,
I am trying to integrate Lansweeper (Vulnerability section) with PowerBI.
I am using the API documentation to get the data and I have managed so visualize the data but once I try to load it it keeps there for a while until I get the message "Too many Requests".
I have even trying to add some delay between the request to avoid reaching the limit of the API but still stuck on this. Has anyone managed to do this?
I am sure that the API query is good because I am getting the data in powerBI.
PREVIEW ON POWERBI
- Labels:
-
API & Integrations
-
Security
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
3 weeks ago
Hello Andres, the error you are getting is cause you are performing more than 150 calls per minute to our API. Please be sure you add enough delay in order to not reach that limit.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
4 weeks ago
Hello,
Unfortunately, the PowerBI integration was developed for the assetResources query and not the vulnerabilities query in the API. This is most likely why you are running into the “Too many Requests” error, as many vulnerabilities tend to exist on one’s environment. More information regarding the API limits can be found here: API restrictions | Documentation – Lansweeper.
Furthermore, do not hesitate to create a support ticket where we can assist you further there and help you create a feature request for this issue: Support Portal - Lansweeper Community.
Thanks!
