All,
We're going to be porting our old lansweeper over to a new one. I wanted to reach out to the community to see if there is perhaps a best practices guide to a new lansweeper setup.
I'm going to start with setting up the scanning. We have a handful of locations on their own subnets. When I setup the scanner for each subnet should I stagger out the scanning times?
Hoping to configure this to be fast and very useful. We'd like to use Lansweeper for asset management and tie in users to assets and keep a historical record of every person who has used the equipment until the equipment has been retired.
I'm sure there are some other configuration settings I may need to tweak to make sure this data isn't purged. Any helpful advice or tips are very welcome.
Thank you!
