I've a question about freeware version. I downloaded yesterday the last version setup file. I installed and all was fine.
I've configured group policy for pc scanning with lsclient and was fine but the ip range scanning didn't produced anything(and then all the network devices aren't showed).
In lansweeper configuration all the tabs in scanning server section are disabled except some features in first tab and i don't know how the ip range scanning can start and if it starts.
In error output file there aren't lines.
I didn't find a solution about this topic in forums because the answers talking about the tabs that in my workstation are disabled.
lansweeper conf version is 4.1.0.132
Regards,
D.
