Display the switch/port that the asset is connect to

[Jimurray]

Is there an easy way in Lansweeper to display the actual switch and port that the asset is connected to? My devices go through several managed Cisco switches, and I'd like to know which switch and port each device connects to the network from.

[Daniel_B · Accepted solution]

If your switches have successfully been scanned, you will see the switch name and port on the asset page of connected assets under tab Summary, section Network. You will even have a link directly to the asset page of the switch.

This page describes how to scan network devices such as switches. You need to submit the correct SNMP scanning credential and map it to the IP range of the switch under Configuration\Scanning credentials.