cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
ericrsteele
Engaged Sweeper II
Every night Lansweeper scans my LP 2824 Plus and every morning a configuration label prints out. Does any one know why? How can I stop doing that?
1 ACCEPTED SOLUTION
Susan_A
Lansweeper Alumni
Lansweeper scans any device submitted for scanning under Scanning\Scanning Targets. A list of ports queried can be found in this knowledge base article. If your device is printing labels after a scan, we assume it is somehow configured to do so after certain ports are queried.

For information on preventing automatic label printing, I recommend consulting your device documentation. If you would like to prevent Lansweeper from scanning your device altogether, you can either:
  • Adjust your scanning targets under Scanning\Scanning Targets, so the device is not part of any targets.
  • Specifically exclude the device from scanning. Info on setting up exclusions can be found in this knowledge base article.

View solution in original post

1 REPLY 1
Susan_A
Lansweeper Alumni
Lansweeper scans any device submitted for scanning under Scanning\Scanning Targets. A list of ports queried can be found in this knowledge base article. If your device is printing labels after a scan, we assume it is somehow configured to do so after certain ports are queried.

For information on preventing automatic label printing, I recommend consulting your device documentation. If you would like to prevent Lansweeper from scanning your device altogether, you can either:
  • Adjust your scanning targets under Scanning\Scanning Targets, so the device is not part of any targets.
  • Specifically exclude the device from scanning. Info on setting up exclusions can be found in this knowledge base article.

New to Lansweeper?

Try Lansweeper For Free

Experience Lansweeper with your own data.
Sign up now for a 14-day free trial.

Try Now