cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
llucatino
Engaged Sweeper II

Has anyone been successful in setting up SNMP on Cisco C9300L switches which are managed through the Meraki dashboard?  I have enabled local SNMP scanning in the dashboard in the Network-Configure-General-Reporting section using SNMP V1/V2.  Lansweeper does not pull any information from the switch, no hostname, model, serial number, or any port mapping info.  The only thing I was able to get was from a custom OID I setup which gives me the System Name and Model.  Is there something I'm missing for SNMP to work properly?

2 REPLIES 2
FrankSc
Lansweeper Tech Support
Lansweeper Tech Support

Dear, Ilucatino,
Some devices list more information if you scan them with SNMPV3. However, we are not 100% sure if this will work for these switches. 

I would consult the manufacturer to see if this is possible.

llucatino
Engaged Sweeper II

Oddly enough, the switches started pulling information yesterday including the network interface with port mapping.  I didn't change anything and it is using SNMPV2.  Strange how it started t work out of the blue.