
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-15-2011 02:05 PM
Hi there, I am trying to setup file scanning on one of our remote workgroup PC's (scanned with IP Scanning). All other scanning is working fine and results are coming back. Is there anything else that needs configuring to enable this?
The path i am trying to scan is "c:\PSPRODUCTS\owncodes.dbf"
I have set this up and ensured file scanning is set to run every day but no information is coming back on the config/scanned info/file info page.
Any help appreciated.
The path i am trying to scan is "c:\PSPRODUCTS\owncodes.dbf"
I have set this up and ensured file scanning is set to run every day but no information is coming back on the config/scanned info/file info page.
Any help appreciated.
Labels:
- Labels:
-
Archive
4 REPLIES 4

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-18-2011 12:38 PM
Screenshots sent.

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-18-2011 12:25 PM
could you please mail us the screenshots at support@lansweeper.com (with the full information)

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-18-2011 12:13 PM
Hi there. Thanks for the reply.
I have attached the Branch scanning config files to previous post.
tblfileversions is empty.
I have attached the Branch scanning config files to previous post.
tblfileversions is empty.

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-18-2011 11:59 AM
Can you please post or mail screenshots of your configuration. (and output of table tblfileversions"
