
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-27-2011 07:49 PM
So I completed my installation and got things set (or so I thought). I entered a range of IP's that I wanted scanned and have discovered that Lansweeper is scanning my entire domain (over 16,000 devices).
How can I stop the scan and force it just to scan a selected range?
Thanks.
How can I stop the scan and force it just to scan a selected range?
Thanks.
Labels:
- Labels:
-
Archive
4 REPLIES 4

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-27-2011 11:23 PM
Got it. Thanks again.
From what I've seen of Lansweeper so far I'm going to be requesting approval to purchase the software.
From what I've seen of Lansweeper so far I'm going to be requesting approval to purchase the software.

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-27-2011 11:11 PM
Yes, but OU filtering only filters active scanning, not ip range scanning.

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-27-2011 11:04 PM
Thanks . . . I'll look at that setting.
If I leave it enabled will the OU filtering do it's job and only enable active scanning on the container I want to look at?
If I leave it enabled will the OU filtering do it's job and only enable active scanning on the container I want to look at?

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-27-2011 09:15 PM
Most likely active scanning is still enabled, disable it.
