Refresh configuration

[bernardo]

Hi, I added memory on one PC and I can see the upgrade on lansweeper console.
I ran manually TRiger scan" but nothing change. How can I force the refresh to see the new configuration?

I was looking on the lansweeper server configuration and see that under scan options, the schedule scanning field is empty. Is this item related to the problem I mentioned?

[Hemoco]

Each name should map to the corresponding table with the same name.

Do you have any specific items that are not clear?

[bernardo]

Ok.
Is there any manual where I can to see what each item of the configuration utility means?

[Hemoco]

In the configuration tool you need to check the "scan options", "item wait time"
This defines what is scanned every X days.

You don't need to configure scheduled scanning.

[bernardo]

What is "waittime" for memory?
At the other hand, should I configure schedule scanning to reflect modifications on networks pcs or it´s unnecesary?

[bernardo]

After a pair of minutes of running lstrigger from comand prompt, the configuration show the change in memory. I look at the custom actions, and see that the comand was write with myserver variable, I change it with the server netbios name, and now when I run trigger now from action screen it works well.
But, why the memory change that´s not reflect automatically?

[Hemoco]

bernardo wrote:
But, why the memory change that´s not reflect automatically?

You have to check the "waittime" for memory.

[bernardo]

I run lstrigger from the option in the action screen.
There I see "last seen" field, and is 10/29/2009 07:32:11. Its old. But I lunch "trigger scan" and nothing change.
I run from comand promp of my server lstrigger myserver pc domain, and the field last seen change, but the amount of memory doesnt change

[Hemoco]

Are you sure that the lstrigger command is correct?
On the action screen page you can see at the bottom the "last scanned" dates.