Scan selected IP ranges now?

[poweld1]

I can see that you can scan all enabled IP ranges now but I was wondering is it possible to scan a selected ip range on demand?

[rvgfox]

I have several subnets.

It would be nice to be able to have an action to scan a IP location on demand.

[Hemoco]

rvgfox wrote:
I have several subnets.

It would be nice to be able to have an action to scan a IP location on demand.

You'll have to disable the other ranges and hit the Scan All Enabled IP Ranges Now button. Additional buttons will most likely not be implemented.

[Hemoco]

Could you provide some further information on this. If you only wish to rescan a particular IP range, simply disable the other ranges first.

[poweld1]

Lansweeper wrote:
Could you provide some further information on this. If you only wish to rescan a particular IP range, simply disable the other ranges first.

That's not a bad idea actually. I just thought you could have a button next to a particular ip range and be able to just scan that range instead of all ip ranges.

[Hemoco]

poweld1 wrote:

Lansweeper wrote:
Could you provide some further information on this. If you only wish to rescan a particular IP range, simply disable the other ranges first.

That's not a bad idea actually. I just thought you could have a button next to a particular ip range and be able to just scan that range instead of all ip ranges.

This will most likely not be implemented, as you can disable ranges and rescan just the ones you need using the Scan All Enabled IP Ranges Now button. In Lansweeper 5.0, there is a button under IP Range Scanning to disable/enable all ranges. You can then easily re-enable just the ones you need.