Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-20-2021 04:02 PM
When having more than 1 scanserver with error the name does not appear anymore under the exclamation mark triangle.
Labels:
- Labels:
-
General Discussion
3 REPLIES 3
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-22-2021 04:47 PM
Still no solution here. Any ideas?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-20-2021 05:51 PM
Not sure that's the issue. I have had it several times in the past. As soon as the Lansweeper service was started on the first server, that one disapeared and the next server, where the service was not running showed.
Now I can not enable the service on the first server, as it is offline for some time. So I need to know which one is the second...
Now I can not enable the service on the first server, as it is offline for some time. So I need to know which one is the second...
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-20-2021 05:13 PM
All scanning servers are normally stored in the table tsysASServers. this server is probably not listed anymore there.
Could you try reinstalling the scanning service only on that scanning server and point it again to your database? This should solve it normally.
https://www.lansweeper.com/knowledgebase/setting-up-an-installation-with-multiple-scanning-servers/
Could you try reinstalling the scanning service only on that scanning server and point it again to your database? This should solve it normally.
https://www.lansweeper.com/knowledgebase/setting-up-an-installation-with-multiple-scanning-servers/