Cisco SSH Credencial

[RemiB]

Hello Lanseeper Community, i have issue with scanning my Cisco Switch.

- in my IP range the (no ssh) box not checked.

-In my switch config SSH is enable and i create an acount with full acces(15) 

-After that i made a ssh credential on lansweeper with the right user name and password and i put the credential on my ip range .

What im doing wrong?

[mwrobo09]

RemiB,

Did you map the credential to the IP of that device, or to the scanning range under Scanning Credentials and then down below in the Credential Mapping section?