→ Celebrate SysAdmin Day 2024 with Lansweeper Enter our Giveaway here

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
calogero_dimagg
Engaged Sweeper II
Hi at all,

I discovered a CX311 Huawei switch, but the discovered serial number is not the "product serial number", it correspond to a physical serial number. The OID used by Lansweeper to discovery CX311 is 1.3.6.1.4.1.2011.2.271.2.

I try to change the OID on "Asset Mapping" adding this OID 1.3.6.1.2.1.47.1.1.1.1, but the result it's the same.

Someon have the same issue or an idea?

thanks at all 😉
1 REPLY 1
Esben_D
Lansweeper Employee
Lansweeper Employee
Hi Calogero,

The serial number scanned from a switch really depends on what SNMP gives back. Unfortunately, if the wrong serial number is given back, there is not much you can do other then manually entering the correct one.

OID Mapping is only intended to correctly identify the asset's type. It has no influence on the way the asset is scanned.