
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-11-2014 04:58 PM
I removed 2GB of memory from a computer and when I got back to my desk I ran lsclient on the computer to update the amount of memory. The scan succeeded and the Last Seen date updated but the memory is still showing the original amount instead of the reduced amount. Is there some place I'm supposed to adjust the frequency at which certain things are re-scanned?
Thanks
Thanks
Solved! Go to Solution.
Labels:
- Labels:
-
General Discussion
1 ACCEPTED SOLUTION

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-11-2014 06:06 PM
On the page configuration/item wait times you can configure the frequency that an item of an asset is re-scanned. You can also see in the scan time tab on a asset page how long ago a specific item is scanned.
2 REPLIES 2

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-24-2014 09:23 PM
That's what I needed to know. Was able to modify the scan frequency and it picked up the new memory amounts just fine. Thanks!

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎07-11-2014 06:06 PM
On the page configuration/item wait times you can configure the frequency that an item of an asset is re-scanned. You can also see in the scan time tab on a asset page how long ago a specific item is scanned.
