IP Range vs IP Scanned

[aplrich]

I don't even know where to begin with this so i'm hoping someone can help.

What I would like to do, is have a report that lists every single IP address in a range, presumably this would be created on the fly unless the lansweeper start / end ip fields could be leveraged.

I would then like to compare this to ip addresses in the asset IPNumeric field and list assets where there is a match. Where there isn't a match the row would just be blank with the exception of the IP address. For example.

10.10.10.1 Asset Name Asset IP
10.10.10.2 Asset Name Asset IP
10.10.10.3
10.10.10.4 Asset Name Asset IP

Is this at all possible?

[l2hawk]

aplrich - Did you have any success yet? We are also looking to track available IP addresses in a VLAN.

[aplrich]

You say that but where there is a will there is a way!

What about, importing a range of IP addresses as 'assets' for which you could create a custom asset type. Could you then create a report that matched the IP 'Asset Name' to the IPNumeric field of scanned assets?

That would achieve a similar output no?

[Nick_VDB · Accepted solution]

If an IP address is not being used then an asset is not made and the IP is not stored in the Lansweeper database.Since they are not stored in the database they cannot be added to the report. Lansweeper was not designed as an IP address management tool so achieving what you are trying to do will unfortunately not be possible with the features that are currently in Lansweeper.