
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎03-14-2014 05:18 PM
How can I stop Lansweeper from scanning/adding Monitors, Switches, or "Webservers", etc... I only want it to scan Computers and Printers.
Solved! Go to Solution.
Labels:
- Labels:
-
Archive
1 ACCEPTED SOLUTION
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎01-17-2015 01:14 AM
FYI for everyone: asset type exclusions were added in Lansweeper 5.2.
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎01-17-2015 01:14 AM
FYI for everyone: asset type exclusions were added in Lansweeper 5.2.

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎03-14-2014 09:49 PM
Ok after doing some searching I learned that there is no way to stop Lansweeper from adding a particular asset type. I am surprised at this actually...
I found a post where this feature was basically requested, here was my reply...
I am also VERY interested in this feature...
I will go a bit further and ask for the ability to choose not to add certain asset types (not just monitors). I only want to see my workstations and servers. With one IP address, you can have a workstation, printer, monitor, webserver, and you end up with a huge mess of things we don't need or want to see. If I block that IP address, then I lose the workstation from the list as well. Why would anyone want that? I understand a lot of people use this to scan everything under the sun. I would like the option to scan everything, but only ADD the asset types I choose to add.
Thanks... LOVE Lansweeper... this feature would make it absolutely FLAWLESS for us. 🙂
I found a post where this feature was basically requested, here was my reply...
I am also VERY interested in this feature...
I will go a bit further and ask for the ability to choose not to add certain asset types (not just monitors). I only want to see my workstations and servers. With one IP address, you can have a workstation, printer, monitor, webserver, and you end up with a huge mess of things we don't need or want to see. If I block that IP address, then I lose the workstation from the list as well. Why would anyone want that? I understand a lot of people use this to scan everything under the sun. I would like the option to scan everything, but only ADD the asset types I choose to add.
Thanks... LOVE Lansweeper... this feature would make it absolutely FLAWLESS for us. 🙂
