‎04-14-2020 11:35 PM
‎02-09-2023 10:15 AM
It would be great if the lsagent (along with an install of npcap of course) could be nominated in the GUI for each vlan/site to capture this data and send to the LanSweeper server.
‎04-22-2022 03:59 PM
‎04-26-2022 10:24 PM
Mr. Adam wrote:
I know this post is old but this is our solution.
Our deployment is 9 sites (9 scanning servers) and about 30 VLANs per site.
The addition of an additional dedicated NIC on the lansweeper server and connect it as a trunk port with allow all vlans.
I believe it is important to use a dedicated NIC because it will receive broadcast traffic from all vlans and so, could become quite busy (ie like not having vLANs).
‎02-18-2021 03:32 AM
‎04-15-2020 01:56 PM
danielm wrote:
Correct me if im wrong, but, unless the 'lansweeper' server is put on a mirroring switch port on a main switch,
its not going to capture anything other than broadcast traffic that just happens to find its way near the lansweeper server.
non?
Is there a specific desired setup for this feature.
Experience Lansweeper with your own data. Sign up now for a 14-day free trial.
Try Now