Showing results for 
Show  only  | Search instead for 
Did you mean: 
Engaged Sweeper
So, i noticed our AP's just show as a "network device" and decided we need to clean this up. after adding the MIBs i got the OIDs scanned however the AP's don't populate. after looking at this closer i noticed that the OIDs are different for each AP (obviously) and as such lansweeper is not scanning/adding them.

Here's an example:
Scanned OID (AP Name): (as defined by the MIB)
OID of AP:

i looked through all of our AP's they all have OID's that begin with is there a wildcard or something i need to put on the end of these OID's in order for it to actually include these? or how do i go about scanning these properly?

Currently on Version
Engaged Sweeper II

Did you ever figure this out?