‎10-26-2016 12:12 AM
Solved! Go to Solution.
‎01-30-2017 01:00 PM
‎02-09-2017 06:55 PM
‎01-30-2017 01:00 PM
‎01-30-2017 11:46 AM
darrkon wrote:
Hi,
We have some DELL PowerConnect switches (N2000, N4000 and S6000). LANSweeper has used SNMP to grab information from the device, but for some reason, the Interface information keeps displaying the same port channel interface over and over again.
I have pasted the first couple of lines from LANSweeper below from the switch named R11-N2K-01.. this basically repeats where the only change per line is the IF number (first number):
1 Po29 Link to R11-N2K-01 Unit: 1 Slot: 0 Port: 1 Gigabit - Level Ethernet Up 1518 F4:8E:38:23:CD:86 r11-n4k-01 1 | Unit: 1 Slot: 0 Port: 1 Gigabit - Level (Po29 - Link to R11-N2K-01) Data-VLAN
r11-n4k-02 1 | Unit: 1 Slot: 0 Port: 1 Gigabit - Level (Po29 - Link to R11-N2K-01)
2 Po29 Link to R11-N2K-01 Unit: 1 Slot: 0 Port: 2 Gigabit - Level Ethernet Up 1518 F4:8E:38:23:CD:86 r11-n4k-01 2 | Unit: 1 Slot: 0 Port: 2 Gigabit - Level (Po29 - Link to R11-N2K-01) Data-VLAN
r11-n4k-02 2 | Unit: 1 Slot: 0 Port: 2 Gigabit - Level (Po29 - Link to R11-N2K-01)
I would expect to see this information, but also a list of connected hosts for R11-N2K-01 (as we would get from a Cisco switch).
Has anyone had any experience with PowerConnect switches in LANSweeper and can assist?
Thanks,
Luke
Experience Lansweeper with your own data. Sign up now for a 14-day free trial.
Try Now