I have SNMP turned on for my Cisco devices and it works fine. Is it possible to pull the IP per port to link the port to a device when the MAC isn't available?
Unfortunately this is not possible in Lansweeper. It was decided beforehand not to use the IP address of a device as they are not as unique as a MAC address and could cause Lansweeper to wrongly identify the device connected to the switch port.
Unfortunately this is not possible in Lansweeper. It was decided beforehand not to use the IP address of a device as they are not as unique as a MAC address and could cause Lansweeper to wrongly identify the device connected to the switch port.
General Discussions
Find answers to technical questions about Lansweeper.
