Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎08-18-2020 09:16 PM
Under Configuration -> Scanning Options we have the setting "Set assets to non-active if not seen in the last" set to 180 days. Today I found a computer that had been turned off for a while. I looked in Lansweeper and it was set to non-active. I booted the computer and after lansweeper scanned it, all the data was populated. The asset is still inactive. Is there a way to make non-active assets active once they are booted and scanned by Lansweeper?
Solved! Go to Solution.
Labels:
- Labels:
-
General Discussion
1 ACCEPTED SOLUTION
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎08-18-2020 09:53 PM
I see the option to automatically make non-active assets active when they are rescanned. I just didn't look close enough in settings.
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎08-18-2020 09:53 PM
I see the option to automatically make non-active assets active when they are rescanned. I just didn't look close enough in settings.