
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎03-29-2019 11:08 AM
in the network interface overview I can see the connect Asset. The Cisco 2950/2960/3750 series works fine too, but the Cisco 9200/9300/9500 series does not show the asset column.
Can anyone give me a tip, so that the assets are displayed here?
Beautiful greetings and a nice weekend,
Matze
- Labels:
-
General Discussion

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎10-12-2022 04:14 PM
We had a similar situation and had a @ symbol in the community name and created a new one without the symbol and worked fine after that.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-29-2019 01:43 PM
Matze wrote:
Hello,
in the network interface overview I can see the connect Asset. The Cisco 2950/2960/3750 series works fine too, but the Cisco 9200/9300/9500 series does not show the asset column.
Can anyone give me a tip, so that the assets are displayed here?
Beautiful greetings and a nice weekend,
Matze
Also, check this :
https://netscantools.blogspot.com/2013/07/configuring-cisco-ios-switches-for-use.html

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-26-2019 10:25 AM
You can aslo follow this guide for some troubleshooting: https://www.lansweeper.com/knowledgebase/troubleshooting-snmp-scanning-issues/

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-26-2019 08:47 AM
I think the SNMP Oid for Cisco 9200 is missing in Asset Mapping.
Kind regards,
Matthias

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-10-2019 08:00 AM
on the Cisco 9200, this information is no longer scanned:
"Network: Intel(R) Ethernet Connection I217-V - 90:1B:0E:xx.xx:xx
1.xxx.xxx.xxx switch-name 25 | FastEthernet0/25 (Fa0/25)
09/04/2019 12:01:32"
What can I do to get this information scanned again?
Kind regards,
matthias

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-02-2019 11:03 AM
I mean the overview of a single asset.
See the picture: https://imgur.com/A0oc4x0
Kind regards,
Matthias

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎04-02-2019 09:35 AM
This KB article also has some good tips on how to find assets: https://www.lansweeper.com/knowledgebase/no-asset-created-for-scanned-computer-or-device/
