Can not scan of asset Cisco Access Point under WLC.

[Nichamon]

Hi,

I have Cisco Access Point that managed by WLC (Lansweeper can scan WLC which) but Lansweeper can not scan access point. I have try Devices Tester and it shown 

Scanning SSH..
SSH server: SSH-2.0-OpenSSH_8.5
System info: can't get tty settingscan't set orig mode
Hostname: can't get tty settingscan't set orig mode
Kernel name: can't get tty settingscan't set orig mode
Kernel release: can't get tty settingscan't set orig mode
Kernel version: can't get tty settingscan't set orig mode
Processors: can't get tty settingscan't set orig mode
VMware product name: can't get tty settingscan't set orig mode
VMware vendor name: can't get tty settingscan't set orig mode
Disks: can't get tty settingscan't set orig mode
Network: can't get tty settingscan't set orig mode

Already have config SSH credentials and map credential and targets.

[Obi_1_Cinobi]

Hello there!

Perhaps you can contact the vendor to see if they can assist you with obtaining the correct OIDs.

Alternatively, you can browse our MIB library to see if the OID information is already present there. More details on our MIB library can be found here:https://community.lansweeper.com/t5/scanning-your-network/introduction-to-the-mib-importer-and-mib-l...

[Nichamon]

Appreciate, Maybe I can't config that right way.

[Obi_1_Cinobi]

Hello there!

As already pointed out by @Mister_Nobody , for scanning network devices, we usually recommend scanning them via SNMP instead of SSH. It could be that your network device will not be able to interpret the SSH commands that Lansweeper uses, as these are targeted explicitly at true Linux/Unix systems.

For more information on scanning network devices, you can refer to this KB article: https://community.lansweeper.com/t5/requirements/network-device-scanning-requirements/ta-p/64380

[Mister_Nobody]

Use SNMP