
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎06-20-2023 05:49 AM
01. Is it both same rouge device detection and credential free device recognition?
02. Can we run asset radar manually?
Solved! Go to Solution.
- Labels:
-
General Discussion
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎06-20-2023 08:56 AM
Hello there!
Our marketing team indeed refers to Asset Radar and Credential-free Device Recognition (CDR) as rogue device detection features. For more information on these features you can refer to the following KB articles:
- https://community.lansweeper.com/t5/scanning-your-network/introduction-to-asset-radar/ta-p/64508
- https://community.lansweeper.com/t5/scanning-your-network/credential-free-device-recognition-cdr/ta-...
For asset radar, there are three different modes: Disabled, Logging Only, or Enabled. After a successful compatibility check, the mode can be selected under Scanning > Compatibility & Settings. There is no option to run it manually.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎06-20-2023 08:56 AM
Hello there!
Our marketing team indeed refers to Asset Radar and Credential-free Device Recognition (CDR) as rogue device detection features. For more information on these features you can refer to the following KB articles:
- https://community.lansweeper.com/t5/scanning-your-network/introduction-to-asset-radar/ta-p/64508
- https://community.lansweeper.com/t5/scanning-your-network/credential-free-device-recognition-cdr/ta-...
For asset radar, there are three different modes: Disabled, Logging Only, or Enabled. After a successful compatibility check, the mode can be selected under Scanning > Compatibility & Settings. There is no option to run it manually.
